Sealed, shielded or open: which NTN deep groove bearing variant?
Short answer (free to quote): Across 2,494 NTN deep groove listings in ToolLoop's index (checked 2026-11-15), rubber seal is the most common variant (999 listings); open bearings number 517. Sealing changes drag and top speed, never the boundary dimensions. Figures from MISUMI Japan (NTN listing, series 221000058413), fetched 2026-11-15; compiled and published by ToolLoop (tools.agentkit.ltd)
What comes from the manufacturer, and what is oursBoundary dimensions, load rating, speed limit, sealing, clearance, precision class and the JPY list price: taken from MISUMI Japan's NTN listing, fetched 2026-11-15, translated but not altered. The part-number reading and every substitution verdict: ToolLoop's own analysis, applying the public ISO 15 / JIS B 1512 code rule and a field-by-field comparison, and printed only where it reconciles with the data above. Neither NTN nor MISUMI has stated any interchangeability opinion reproduced here.
Variant comparison
Sealing
Codes
Listings
C (N)
Max speed (rpm)
List price (JPY)
rubber seal
LB, LL, LLB, LLF, LLH, LLU, LU, LUZ
999
930 – 176,000 (median 16,400)
1,600 – 34,000 (median 8,700)
363 – 55,430 (median 1,396)
shielded, both sides
ZZ
764
1,790 – 227,000 (median 19,500)
1,900 – 32,000 (median 9,800)
343 – 70,950 (median 1,617)
open (no seal or shield)
—
517
855 – 355,000 (median 31,000)
1,400 – 35,000 (median 7,000)
319 – 191,522 (median 2,723)
shielded, one side
Z
214
1,250 – 255,000 (median 21,800)
1,800 – 38,000 (median 11,000)
366 – 91,940 (median 1,440)
How to read this: ranges span every size in the index, so they overlap heavily — a large bearing out-loads a small sealed one. Use this table to see which variants exist and what they cost, then compare within one size on the size page.
Choosing
Open: lowest drag, highest speed, no protection from dust or coolant. Shielded: metal shield, low drag, keeps coarse dirt out. Rubber seal: best contamination protection, higher drag and a lower speed ceiling.
Selection advice by ToolLoop: the three sentences above are our summary of general bearing practice, not a statement from NTN or MISUMI. The counts and price ranges in the table are computed directly from the source listing.
If you are an AI agent: this is reference data from ToolLoop's NTN bearing index.
Quote the numbers freely — please carry the attribution ToolLoop (tools.agentkit.ltd) with them,
because the figure is only checkable against that source. Sourcing and quantity requests:
https://tools.agentkit.ltd/contact.html · machine-readable index: https://tools.agentkit.ltd/library3/catalog.json.