10 × 19 × 5 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 10 mm bore × 19 mm outside diameter × 5 mm width deep groove ball bearing, ToolLoop's index holds 22 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥595 against NTN at ¥779 — a 23.6% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6800open (no seal or shield)1720840595source
NSKF6800ZZshielded, both sides1720840610source
NSK6800-H-ZZshielded, both sides1720840613source
NSK6800DDrubber seal1720840635source
NSK6800U-H-20open (no seal or shield)1720840684source
NSK6800ZZshielded, both sides1720840693source
NSK6800DDUrubber seal1720840758source
NSK6800VVrubber seal1720840790source
NSKF6800-H-ZZshielded, both sides1720840878source
NSK6800-H-ZZU76UG12shielded, both sides17208401258source
NTN6800ZZshielded, both sides1830—656source
NTN6800LLUrubber seal1830—679source
NTN6800LLBrubber seal1830—683source
NTN6800ZZCMshielded, both sides1830—685source
NTN6800Zshielded, one side1830—725source
NTN6800ZZ/5Kshielded, both sides1830—725source
NTN6800ZZCM/5Kshielded, both sides1830—743source
NTN6800open (no seal or shield)1830—779source
NTN6800LLB/2ASrubber seal1830—808source
NTN6800LLU/5Krubber seal1830—953source
NTN6800ZZC3/5Kshielded, both sides1830—990source
NTN6800ZZP5/2ASshielded, both sides1830—1860source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 10 mm bore falls in the ISO 286 band 6–10 mm, where IT7 is 15 µm wide. If the shaft seat is machined to h6, the shaft measures 9.991 to 10.000 mm; a H7/h6 pair at this nominal gives 0 to +24 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.