130 × 200 × 33 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 130 mm bore × 200 mm outside diameter × 33 mm width deep groove ball bearing, ToolLoop's index holds 13 listings across NTN and NSK. In the sealed variant the cheapest listing is NSK at ¥14,536 against NTN at ¥17,914 — a 18.9% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6026DDUC3rubber seal10600010100014536source
NSK6026Zshielded, one side10600010100015355source
NSK6026C3open (no seal or shield)10600010100015392source
NSK6026open (no seal or shield)10600010100015699source
NSK6026ZZshielded, both sides10600010100017681source
NSK6026Mopen (no seal or shield)10600010100021385source
NSK6026P5open (no seal or shield)10600010100046026source
NTN6026C3open (no seal or shield)106000—14170source
NTN6026CMopen (no seal or shield)106000—14170source
NTN6026ZCMshielded, one side106000—15942source
NTN6026LLUrubber seal106000—17914source
NTN6026LLU/2ASrubber seal106000—21222source
NTN6026ZZshielded, both sides106000—22162source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 130 mm bore falls in the ISO 286 band 120–180 mm, where IT7 is 40 µm wide. If the shaft seat is machined to h6, the shaft measures 129.975 to 130.000 mm; a H7/h6 pair at this nominal gives 0 to +65 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.