130 × 230 × 40 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 130 mm bore × 230 mm outside diameter × 40 mm width deep groove ball bearing, ToolLoop's index holds 11 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥21,126 against NTN at ¥22,190 — a 4.8% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6226open (no seal or shield)16700014600021126source
NSK6226CMopen (no seal or shield)16700014600021217source
NSK6226MC3open (no seal or shield)16700014600033783source
NSK6226Mopen (no seal or shield)16700014600034457source
NTN6226C3open (no seal or shield)167000—22190source
NTN6226C2open (no seal or shield)167000—22633source
NTN6226CMopen (no seal or shield)167000—23128source
NTN6226Zshielded, one side167000—24423source
NTN6226ZZ/2ASshielded, both sides167000—26726source
NTN6226LLU/2ASrubber seal167000—29518source
NTN6226LLUrubber seal167000—30760source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 130 mm bore falls in the ISO 286 band 120–180 mm, where IT7 is 40 µm wide. If the shaft seat is machined to h6, the shaft measures 129.975 to 130.000 mm; a H7/h6 pair at this nominal gives 0 to +65 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.