140 × 210 × 33 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 140 mm bore × 210 mm outside diameter × 33 mm width deep groove ball bearing, ToolLoop's index holds 11 listings across NTN and NSK. In the sealed variant the cheapest listing is NSK at ¥20,789 against NTN at ¥22,746 — a 8.6% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6028open (no seal or shield)11000010900016877source
NSK6028C3open (no seal or shield)11000010900018617source
NSK6028ZZC3shielded, both sides11000010900019400source
NSK6028DDUC3rubber seal11000010900020789source
NSK6028MC3open (no seal or shield)11000010900024831source
NTN6028C3open (no seal or shield)110000—16013source
NTN6028CMopen (no seal or shield)110000—16653source
NTN6028ZZ/2ASshielded, both sides110000—19202source
NTN6028LLUrubber seal110000—22746source
NTN6028LLU/2ASrubber seal110000—23108source
NTN6028ZZshielded, both sides110000—24302source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 140 mm bore falls in the ISO 286 band 120–180 mm, where IT7 is 40 µm wide. If the shaft seat is machined to h6, the shaft measures 139.975 to 140.000 mm; a H7/h6 pair at this nominal gives 0 to +65 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.