160 × 240 × 38 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 160 mm bore × 240 mm outside diameter × 38 mm width deep groove ball bearing, ToolLoop's index holds 14 listings across NTN and NSK. In the shielded variant the cheapest listing is NSK at ¥33,196 against NTN at ¥34,776 — a 4.5% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6032CMopen (no seal or shield)13700013500027744source
NSK6032open (no seal or shield)13700013500028426source
NSK6032C3open (no seal or shield)13700013500028988source
NSK6032Zshielded, one side13700013500033196source
NSK6032ZZshielded, both sides13700013500033231source
NSK6032DDUrubber seal13700013500034809source
NSK6032DDUC3rubber seal13700013500035222source
NSK6032Mopen (no seal or shield)13700013500042017source
NSK6032MC3open (no seal or shield)13700013500042017source
NTN6032CMopen (no seal or shield)143000—27177source
NTN6032C3open (no seal or shield)143000—28285source
NTN6032ZZ/2ASshielded, both sides143000—34776source
NTN6032LLU/2ASrubber seal143000—35854source
NTN6032ZZshielded, both sides143000—45793source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 160 mm bore falls in the ISO 286 band 120–180 mm, where IT7 is 40 µm wide. If the shaft seat is machined to h6, the shaft measures 159.975 to 160.000 mm; a H7/h6 pair at this nominal gives 0 to +65 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.