180 × 320 × 52 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 180 mm bore × 320 mm outside diameter × 52 mm width deep groove ball bearing, ToolLoop's index holds 5 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥62,343 against NTN at ¥72,510 — a 14.0% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6236CEopen (no seal or shield)22700024100062343source
NSK6236ZSshielded, one side22700024100067370source
NSK6236MC3open (no seal or shield)227000241000110726source
NTN6236ZZ/2ASshielded, both sides227000—70950source
NTN6236open (no seal or shield)227000—72510source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 180 mm bore falls in the ISO 286 band 120–180 mm, where IT7 is 40 µm wide. If the shaft seat is machined to h6, the shaft measures 179.975 to 180.000 mm; a H7/h6 pair at this nominal gives 0 to +65 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.