100 × 180 × 34 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 100 mm bore × 180 mm outside diameter × 34 mm width deep groove ball bearing, ToolLoop's index holds 19 listings across NTN and NSK. In the open variant the cheapest listing is NTN at ¥7,051 against NSK at ¥8,109 — a 15.0% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6220C3open (no seal or shield)122000930008109source
NSK6220open (no seal or shield)122000930008798source
NSK6220DDUrubber seal122000930008856source
NSK6220VVrubber seal122000930008876source
NSK6220MC3open (no seal or shield)1220009300010765source
NSK6220Mopen (no seal or shield)1220009300011393source
NSK6220P5open (no seal or shield)1220009300024259source
NTN6220open (no seal or shield)122000—7051source
NTN6220ZZCMshielded, both sides122000—7445source
NTN6220CMopen (no seal or shield)122000—7845source
NTN6220C3open (no seal or shield)122000—8325source
NTN6220ZZC3shielded, both sides122000—8426source
NTN6220ZZC3/5Kshielded, both sides122000—9033source
NTN6220ZZCM/5Kshielded, both sides122000—9033source
NTN6220LLBrubber seal122000—9072source
NTN6220Zshielded, one side122000—9116source
NTN6220NRopen (no seal or shield)122000—9404source
NTN6220ZZNRshielded, both sides122000—9828source
NTN6220LLBCM/5Krubber seal122000—10223source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 100 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 99.978 to 100.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.