105 × 160 × 26 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 105 mm bore × 160 mm outside diameter × 26 mm width deep groove ball bearing, ToolLoop's index holds 14 listings across NTN and NSK. In the sealed variant the cheapest listing is NSK at ¥10,263 against NTN at ¥12,044 — a 14.8% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6021CMopen (no seal or shield)72500660008304source
NSK6021open (no seal or shield)72500660008433source
NSK6021CEopen (no seal or shield)72500660008589source
NSK6021VVrubber seal725006600010263source
NSK6021DDUC3rubber seal725006600010831source
NSK6021ZZshielded, both sides725006600010972source
NSK6021P5open (no seal or shield)725006600028215source
NTN6021CMopen (no seal or shield)72500—8202source
NTN6021C4open (no seal or shield)72500—9265source
NTN6021ZZC3/5Kshielded, both sides72500—10619source
NTN6021Zshielded, one side72500—10625source
NTN6021ZZCM/5Kshielded, both sides72500—10625source
NTN6021LUrubber seal72500—12044source
NTN6021LLU/2ASrubber seal72500—12269source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 105 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 104.978 to 105.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.