110 × 170 × 28 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 110 mm bore × 170 mm outside diameter × 28 mm width deep groove ball bearing, ToolLoop's index holds 16 listings across NTN and NSK. In the sealed variant the cheapest listing is NSK at ¥13,381 against NTN at ¥16,447 — a 18.6% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6022Zshielded, one side850007300011395source
NSK6022C3open (no seal or shield)850007300011960source
NSK6022ZZshielded, both sides850007300012022source
NSK6022open (no seal or shield)850007300013086source
NSK6022VVrubber seal850007300013381source
NSK6022DDUC3rubber seal850007300013871source
NSK6022DDUrubber seal850007300013972source
NSK6022Mopen (no seal or shield)850007300016548source
NSK6022MC3open (no seal or shield)850007300016548source
NSK6022P5open (no seal or shield)850007300038264source
NTN6022C3open (no seal or shield)82000—10995source
NTN6022CMopen (no seal or shield)82000—11998source
NTN6022ZZC3shielded, both sides82000—12243source
NTN6022ZZCM/5Kshielded, both sides82000—12604source
NTN6022ZZC3/5Kshielded, both sides82000—15193source
NTN6022LLUrubber seal82000—16447source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 110 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 109.978 to 110.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.