120 × 215 × 40 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 120 mm bore × 215 mm outside diameter × 40 mm width deep groove ball bearing, ToolLoop's index holds 12 listings across NTN and NSK. In the shielded variant the cheapest listing is NSK at ¥21,406 against NTN at ¥21,817 — a 1.9% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6224CMopen (no seal or shield)15500013100018603source
NSK6224C4open (no seal or shield)10400013100019244source
NSK6224ZCMshielded, one side15500013100021406source
NSK6224ZZshielded, both sides15500013100023091source
NSK6224MC3open (no seal or shield)15500013100028629source
NTN6224C2open (no seal or shield)155000—18758source
NTN6224CMopen (no seal or shield)155000—19167source
NTN6224C3open (no seal or shield)155000—20329source
NTN6224LLUrubber seal155000—20683source
NTN6224ZZCMshielded, both sides155000—21817source
NTN6224ZZ/2ASshielded, both sides155000—24411source
NTN6224LLU/2ASrubber seal155000—25555source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 120 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 119.978 to 120.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.