12 × 21 × 5 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 12 mm bore × 21 mm outside diameter × 5 mm width deep groove ball bearing, ToolLoop's index holds 14 listings across NTN and NSK. In the open variant the cheapest listing is NTN at ¥578 against NSK at ¥679 — a 17.5% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6801open (no seal or shield)19201040679source
NSK6801DDrubber seal19201040707source
NSK6801DDUrubber seal19201040715source
NSK6801ZZshielded, both sides19201040722source
NSK6801U-H-20open (no seal or shield)19201040797source
NSK6801VVrubber seal19201040813source
NSK6801-H-ZZU76UG6shielded, both sides192010401525source
NTN6801open (no seal or shield)1920—578source
NTN6801ZZ/2ASshielded, both sides1920—730source
NTN6801ZZshielded, both sides1920—740source
NTN6801Zshielded, one side1920—747source
NTN6801LLUrubber seal1920—802source
NTN6801LLB/2ASrubber seal1920—811source
NTN6801LLBrubber seal1920—853source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 12 mm bore falls in the ISO 286 band 10–18 mm, where IT7 is 18 µm wide. If the shaft seat is machined to h6, the shaft measures 11.989 to 12.000 mm; a H7/h6 pair at this nominal gives 0 to +29 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.