140 × 250 × 42 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 140 mm bore × 250 mm outside diameter × 42 mm width deep groove ball bearing, ToolLoop's index holds 11 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥27,317 against NTN at ¥28,359 — a 3.7% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6228open (no seal or shield)16600015000027317source
NSK6228C3Eopen (no seal or shield)16600015000028032source
NSK6228C3open (no seal or shield)16600015000031278source
NSK6228ZSshielded, one side16600015000032260source
NSK6228ZZshielded, both sides16600015000035048source
NTN6228C3open (no seal or shield)166000—28359source
NTN6228CMopen (no seal or shield)166000—28359source
NTN6228ZZshielded, both sides166000—31344source
NTN6228ZZ/2ASshielded, both sides166000—35320source
NTN6228LLU/2ASrubber seal166000—35790source
NTN6228P5open (no seal or shield)166000—90631source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 140 mm bore falls in the ISO 286 band 120–180 mm, where IT7 is 40 µm wide. If the shaft seat is machined to h6, the shaft measures 139.975 to 140.000 mm; a H7/h6 pair at this nominal gives 0 to +65 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.