150 × 225 × 35 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 150 mm bore × 225 mm outside diameter × 35 mm width deep groove ball bearing, ToolLoop's index holds 14 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥22,890 against NSK at ¥25,978 — a 13.5% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6030open (no seal or shield)12600012600021174source
NSK6030C3open (no seal or shield)12600012600021594source
NSK6030CMopen (no seal or shield)12600012600022259source
NSK6030ZZshielded, both sides12600012600025978source
NSK6030ZZC3shielded, both sides12600012600025978source
NSK6030DDUC3rubber seal12600012600028915source
NSK6030Zshielded, one side12600012600030360source
NSK6030MC3open (no seal or shield)12600012600033905source
NSK6030Mopen (no seal or shield)12600012600034587source
NTN6030C4open (no seal or shield)126000—22211source
NTN6030CMopen (no seal or shield)126000—22275source
NTN6030Zshielded, one side126000—22890source
NTN6030LLU/2ASrubber seal126000—28505source
NTN6030ZZshielded, both sides126000—36709source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 150 mm bore falls in the ISO 286 band 120–180 mm, where IT7 is 40 µm wide. If the shaft seat is machined to h6, the shaft measures 149.975 to 150.000 mm; a H7/h6 pair at this nominal gives 0 to +65 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.