15 × 24 × 5 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 15 mm bore × 24 mm outside diameter × 5 mm width deep groove ball bearing, ToolLoop's index holds 14 listings across NTN and NSK. In the open variant the cheapest listing is NTN at ¥673 against NSK at ¥771 — a 14.6% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6802ZZC3shielded, both sides20701260758source
NSK6802open (no seal or shield)20701260771source
NSK6802ZZshielded, both sides20701260806source
NSK6802DDrubber seal20701260845source
NSK6802DDUrubber seal20701260845source
NSK6802-H-20ZZshielded, both sides20701260924source
NSK6802VVrubber seal207012601002source
NSK6802-H-20DDrubber seal207012601113source
NTN6802open (no seal or shield)2080—673source
NTN6802Zshielded, one side2080—705source
NTN6802LLUrubber seal2080—757source
NTN6802ZZ/2ASshielded, both sides2080—770source
NTN6802ZZshielded, both sides2080—779source
NTN6802LLBrubber seal2080—825source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 15 mm bore falls in the ISO 286 band 10–18 mm, where IT7 is 18 µm wide. If the shaft seat is machined to h6, the shaft measures 14.989 to 15.000 mm; a H7/h6 pair at this nominal gives 0 to +29 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.