20 × 27 × 4 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 20 mm bore × 27 mm outside diameter × 4 mm width deep groove ball bearing, ToolLoop's index holds 9 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥1,132 against NTN at ¥1,207 — a 6.2% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6704open (no seal or shield)10407291132source
NSK6704ZZshielded, both sides10407291153source
NSK6704DDrubber seal10407291266source
NSK6704U-Hopen (no seal or shield)8855831463source
NSK6704-H-ZZshielded, both sides8855832194source
NSK6704-H-DDrubber seal8855832477source
NTN6704LLFrubber seal1040—1201source
NTN6704open (no seal or shield)1040—1207source
NTN6704LLF/5Krubber seal1040—1325source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 20 mm bore falls in the ISO 286 band 18–30 mm, where IT7 is 21 µm wide. If the shaft seat is machined to h6, the shaft measures 19.987 to 20.000 mm; a H7/h6 pair at this nominal gives 0 to +34 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.