20 × 37 × 9 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 20 mm bore × 37 mm outside diameter × 9 mm width deep groove ball bearing, ToolLoop's index holds 25 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥630 against NTN at ¥765 — a 17.6% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6904C3open (no seal or shield)64003700630source
NSK6904Zshielded, one side64003700683source
NSK6904open (no seal or shield)64003700699source
NSK6904CMopen (no seal or shield)64003700702source
NSK6904ZZshielded, both sides64003700752source
NSK6904ZZC3Eshielded, both sides64003700787source
NSK6904DDUrubber seal64003700814source
NSK6904ZZNRshielded, both sides64003700844source
NSK6904VVrubber seal64003700912source
NSK6904U-H-20T1Xopen (no seal or shield)640037001408source
NSK6904-H-ZZU76UG9shielded, both sides640037003308source
NTN6904Zshielded, one side6400—701source
NTN6904ZZshielded, both sides6400—730source
NTN6904LLBrubber seal6400—751source
NTN6904open (no seal or shield)6400—765source
NTN6904LLUNRrubber seal6400—798source
NTN6904LLB/2ASrubber seal6400—804source
NTN6904ZZNRshielded, both sides6400—827source
NTN6904ZZNR/2ASshielded, both sides6400—850source
NTN6904LLUrubber seal6400—852source
NTN6904LLU/2ASrubber seal6400—869source
NTN6904ZZC3shielded, both sides6400—889source
NTN6904LLUNR/2ASrubber seal6400—893source
NTN6904ZZC3/5Kshielded, both sides6400—931source
NTN6904LUrubber seal6400—1080source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 20 mm bore falls in the ISO 286 band 18–30 mm, where IT7 is 21 µm wide. If the shaft seat is machined to h6, the shaft measures 19.987 to 20.000 mm; a H7/h6 pair at this nominal gives 0 to +34 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.