25 × 42 × 9 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 25 mm bore × 42 mm outside diameter × 9 mm width deep groove ball bearing, ToolLoop's index holds 26 listings across NTN and NSK. In the open variant the cheapest listing is NTN at ¥709 against NSK at ¥800 — a 12.8% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6905Zshielded, one side70504550728source
NSK6905ZZNX1Rshielded, both sides70504550757source
NSK6905open (no seal or shield)70504550800source
NSK6905DDUrubber seal70504550842source
NSK6905ZZNRshielded, both sides70504550863source
NSK6905VVrubber seal70504550890source
NSK6905ZZshielded, both sides70504550926source
NSK6905CMopen (no seal or shield)705045501024source
NSK6905U-H-20T1Xopen (no seal or shield)705045501420source
NSK6905-H-20T1XZZshielded, both sides705045501653source
NSK6905-H-ZZU76UG12shielded, both sides705045503273source
NTN6905open (no seal or shield)7050—709source
NTN6905ZZCMshielded, both sides7050—826source
NTN6905ZZNRshielded, both sides7050—848source
NTN6905LLB/2ASrubber seal7050—855source
NTN6905Zshielded, one side7050—860source
NTN6905ZZshielded, both sides7050—861source
NTN6905LLUrubber seal7050—932source
NTN6905NRopen (no seal or shield)7050—935source
NTN6905ZZNR/2ASshielded, both sides7050—954source
NTN6905LLU/2ASrubber seal7050—1014source
NTN6905C3open (no seal or shield)7050—1020source
NTN6905LLBrubber seal7050—1032source
NTN6905ZZC3/5Kshielded, both sides7050—1090source
NTN6905LLUNR/2ASrubber seal7050—1240source
NTN6905ZZ/LP03shielded, both sides7050—1250source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 25 mm bore falls in the ISO 286 band 18–30 mm, where IT7 is 21 µm wide. If the shaft seat is machined to h6, the shaft measures 24.987 to 25.000 mm; a H7/h6 pair at this nominal gives 0 to +34 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.