28 × 68 × 18 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 28 mm bore × 68 mm outside diameter × 18 mm width deep groove ball bearing, ToolLoop's index holds 9 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥1,181 against NSK at ¥1,940 — a 64.3% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK63/28open (no seal or shield)26700140001350source
NSK63/28DDUJrubber seal26700140001893source
NSK63/28Zshielded, one side26700140001940source
NTN63/28ZZshielded, both sides26700—1181source
NTN63/28C3open (no seal or shield)2670 (inconsistent with other listings of this size)—1270source
NTN63/28NRopen (no seal or shield)2670 (inconsistent with other listings of this size)—1410source
NTN63/28ZZ/2ASshielded, both sides26700—1477source
NTN63/28open (no seal or shield)26700—1510source
NTN63/28LLUrubber seal26700—2061source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 28 mm bore falls in the ISO 286 band 18–30 mm, where IT7 is 21 µm wide. If the shaft seat is machined to h6, the shaft measures 27.987 to 28.000 mm; a H7/h6 pair at this nominal gives 0 to +34 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.