30 × 47 × 9 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 30 mm bore × 47 mm outside diameter × 9 mm width deep groove ball bearing, ToolLoop's index holds 25 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥669 against NTN at ¥940 — a 28.8% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6906C3open (no seal or shield)72505000669source
NSK6906CMopen (no seal or shield)72505000817source
NSK6906ZZC3shielded, both sides72505000831source
NSK6906Zshielded, one side72505000935source
NSK6906open (no seal or shield)72505000945source
NSK6906ZZNRshielded, both sides725050001067source
NSK6906ZZshielded, both sides725050001089source
NSK6906DDUrubber seal725050001108source
NSK6906VVrubber seal725050001233source
NTN6906ZZC3/5Kshielded, both sides7250—868source
NTN6906ZZC3shielded, both sides7250—871source
NTN6906ZZ/2ASshielded, both sides7250—912source
NTN6906open (no seal or shield)7250—940source
NTN6906Zshielded, one side7250—985source
NTN6906ZZshielded, both sides7250—1001source
NTN6906C3open (no seal or shield)7250—1009source
NTN6906ZZNR/2ASshielded, both sides7250—1025source
NTN6906LLBCM/5Krubber seal7250—1075source
NTN6906LLBCMrubber seal7250—1082source
NTN6906LLB/2ASrubber seal7250—1102source
NTN6906LLUrubber seal7250—1135source
NTN6906LLBrubber seal7250—1138source
NTN6906ZZNRshielded, both sides7250—1138source
NTN6906LLU/2ASrubber seal7250—1171source
NTN6906LUrubber seal7250—1260source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 30 mm bore falls in the ISO 286 band 18–30 mm, where IT7 is 21 µm wide. If the shaft seat is machined to h6, the shaft measures 29.987 to 30.000 mm; a H7/h6 pair at this nominal gives 0 to +34 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.