40 × 52 × 7 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 40 mm bore × 52 mm outside diameter × 7 mm width deep groove ball bearing, ToolLoop's index holds 19 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥1,290 against NSK at ¥1,640 — a 27.1% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6808open (no seal or shield)635055501373source
NSK6808VVrubber seal635055501470source
NSK6808DDrubber seal635055501543source
NSK6808ZZshielded, both sides635055501640source
NTN6808ZZNR/2ASshielded, both sides5100—1290source
NTN6808JRopen (no seal or shield)5100—1291source
NTN6808open (no seal or shield)5100—1368source
NTN6808ZZshielded, both sides5100—1382source
NTN6808LLB/2ASrubber seal5100—1430source
NTN6808ZZ/2ASshielded, both sides5100—1480source
NTN6808JRZZ/2ASshielded, both sides5100—1483source
NTN6808JRLLBrubber seal5100—1575source
NTN6808ZZ/5Kshielded, both sides5100—1590source
NTN6808LLUrubber seal5100—1604source
NTN6808JRZZNRshielded, both sides5100—1707source
NTN6808JRZZshielded, both sides5100—1745source
NTN6808ZZNRshielded, both sides5100—1835source
NTN6808JRLLB/2ASrubber seal5100—1856source
NTN6808LLBrubber seal5100—1900source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 40 mm bore falls in the ISO 286 band 30–50 mm, where IT7 is 25 µm wide. If the shaft seat is machined to h6, the shaft measures 39.984 to 40.000 mm; a H7/h6 pair at this nominal gives 0 to +41 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.