40 × 62 × 12 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 40 mm bore × 62 mm outside diameter × 12 mm width deep groove ball bearing, ToolLoop's index holds 19 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥848 against NTN at ¥1,303 — a 34.9% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6908C3open (no seal or shield)1370010000848source
NSK6908ZZC3shielded, both sides1370010000855source
NSK6908DDUC3rubber seal13700100001093source
NSK6908open (no seal or shield)13700100001130source
NSK6908CMopen (no seal or shield)13700100001193source
NSK6908VVrubber seal13700100001194source
NSK6908ZZshielded, both sides13700100001256source
NSK6908ZZNRshielded, both sides13700100001285source
NSK6908DDUrubber seal13700100001352source
NTN6908ZZ/5Kshielded, both sides12200—1106source
NTN6908ZZ/2ASshielded, both sides12200—1166source
NTN6908ZZshielded, both sides12200—1258source
NTN6908open (no seal or shield)12200—1303source
NTN6908C3open (no seal or shield)12200—1346source
NTN6908Zshielded, one side12200—1350source
NTN6908LLUrubber seal12200—1381source
NTN6908LLBrubber seal12200—1429source
NTN6908ZZNRshielded, both sides12200—1558source
NTN6908ZZ/LP03shielded, both sides12200—1570source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 40 mm bore falls in the ISO 286 band 30–50 mm, where IT7 is 25 µm wide. If the shaft seat is machined to h6, the shaft measures 39.984 to 40.000 mm; a H7/h6 pair at this nominal gives 0 to +41 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.