45 × 58 × 7 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 45 mm bore × 58 mm outside diameter × 7 mm width deep groove ball bearing, ToolLoop's index holds 20 listings across NTN and NSK. In the sealed variant the cheapest listing is NSK at ¥1,514 against NTN at ¥1,698 — a 10.8% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6809DDUrubber seal660061501514source
NSK6809ZZshielded, both sides660061501773source
NSK6809open (no seal or shield)660061501845source
NSK6809VVrubber seal660061502171source
NTN6809JRZZCMshielded, both sides5350—1617source
NTN6809ZZ/5Kshielded, both sides5350—1617source
NTN6809ZZCMshielded, both sides5350—1617source
NTN6809JRZZCM/5Kshielded, both sides5350—1665source
NTN6809open (no seal or shield)5350—1677source
NTN6809JRZZ/5Kshielded, both sides5350—1687source
NTN6809JRZZshielded, both sides5350—1697source
NTN6809LLBrubber seal5350—1698source
NTN6809JRZZ/2ASshielded, both sides5350—1749source
NTN6809JRZshielded, one side5350—1750source
NTN6809ZZCM/5Kshielded, both sides5350—1769source
NTN6809JRopen (no seal or shield)5350—1786source
NTN6809JRLLB/2Arubber seal5350—1817source
NTN6809LLB/2Arubber seal5350—1886source
NTN6809ZZshielded, both sides5350—2214source
NTN6809LLUrubber seal5350—2401source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 45 mm bore falls in the ISO 286 band 30–50 mm, where IT7 is 25 µm wide. If the shaft seat is machined to h6, the shaft measures 44.984 to 45.000 mm; a H7/h6 pair at this nominal gives 0 to +41 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.