45 × 68 × 12 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 45 mm bore × 68 mm outside diameter × 12 mm width deep groove ball bearing, ToolLoop's index holds 14 listings across NTN and NSK. In the sealed variant the cheapest listing is NTN at ¥1,316 against NSK at ¥1,683 — a 27.9% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6909Zshielded, one side14100109001318source
NSK6909ZZshielded, both sides14100109001522source
NSK6909DDUrubber seal14100109001683source
NSK6909VVrubber seal14100109001683source
NTN6909open (no seal or shield)13100—1159source
NTN6909ZZ/2ASshielded, both sides13100—1284source
NTN6909LLU/2ASrubber seal13100—1316source
NTN6909Zshielded, one side13100—1408source
NTN6909ZZshielded, both sides13100—1501source
NTN6909ZZNR/2ASshielded, both sides13100—1651source
NTN6909ZZNRshielded, both sides13100—1713source
NTN6909LLBrubber seal13100—1736source
NTN6909LLUrubber seal13100—1764source
NTN6909LLB/2ASrubber seal13100—1856source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 45 mm bore falls in the ISO 286 band 30–50 mm, where IT7 is 25 µm wide. If the shaft seat is machined to h6, the shaft measures 44.984 to 45.000 mm; a H7/h6 pair at this nominal gives 0 to +41 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.