50 × 65 × 7 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 50 mm bore × 65 mm outside diameter × 7 mm width deep groove ball bearing, ToolLoop's index holds 22 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥1,572 against NSK at ¥2,118 — a 34.7% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6810ZZshielded, both sides640062002118source
NSK6810open (no seal or shield)640062002204source
NSK6810DDUrubber seal640062002230source
NSK6810VVrubber seal640062002239source
NTN6810JRZZC3shielded, both sides6600—1572source
NTN6810ZZC3/5Kshielded, both sides6600—1652source
NTN6810LLB/2ASrubber seal6600—1771source
NTN6810open (no seal or shield)6600—1818source
NTN6810JRLLBrubber seal6600—1854source
NTN6810ZZ/2ASshielded, both sides6600—1871source
NTN6810JRZZ/2ASshielded, both sides6600—1909source
NTN6810JRZZC3/5Kshielded, both sides6600—1980source
NTN6810ZZC3shielded, both sides6600—2014source
NTN6810JRopen (no seal or shield)6600—2031source
NTN6810JRLLU/2ASrubber seal6600—2043source
NTN6810ZZshielded, both sides6600—2103source
NTN6810JRZZshielded, both sides6600—2160source
NTN6810ZZNRshielded, both sides6600—2202source
NTN6810LLUrubber seal6600—2232source
NTN6810JRLLB/2ASrubber seal6600—2236source
NTN6810LLU/2ASrubber seal6600—2293source
NTN6810LLBrubber seal6600—2690source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 50 mm bore falls in the ISO 286 band 30–50 mm, where IT7 is 25 µm wide. If the shaft seat is machined to h6, the shaft measures 49.984 to 50.000 mm; a H7/h6 pair at this nominal gives 0 to +41 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.