50 × 72 × 12 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 50 mm bore × 72 mm outside diameter × 12 mm width deep groove ball bearing, ToolLoop's index holds 14 listings across NTN and NSK. In the open variant the cheapest listing is NTN at ¥1,484 against NSK at ¥1,762 — a 18.7% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6910open (no seal or shield)14500117001762source
NSK6910Zshielded, one side14500117001841source
NSK6910ZZshielded, both sides14500117001850source
NSK6910VVrubber seal14500117001998source
NSK6910DDUrubber seal14500117002039source
NTN6910open (no seal or shield)13400—1484source
NTN6910ZZshielded, both sides13400—1707source
NTN6910Zshielded, one side13400—1710source
NTN6910ZZC3/5Kshielded, both sides13400—1710source
NTN6910NRopen (no seal or shield)13400—1760source
NTN6910LLU/5Krubber seal13400—1798source
NTN6910ZZNRshielded, both sides13400—2001source
NTN6910LLB/2ASrubber seal13400—2096source
NTN6910LLBrubber seal13400—2661source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 50 mm bore falls in the ISO 286 band 30–50 mm, where IT7 is 25 µm wide. If the shaft seat is machined to h6, the shaft measures 49.984 to 50.000 mm; a H7/h6 pair at this nominal gives 0 to +41 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.