55 × 72 × 9 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 55 mm bore × 72 mm outside diameter × 9 mm width deep groove ball bearing, ToolLoop's index holds 14 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥2,042 against NSK at ¥2,703 — a 32.4% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6811open (no seal or shield)880085002148source
NSK6811ZZshielded, both sides880085002703source
NSK6811DDUrubber seal880085002750source
NSK6811VVrubber seal880085002777source
NTN6811JRZZshielded, both sides8800—2042source
NTN6811open (no seal or shield)8800—2077source
NTN6811JRopen (no seal or shield)8800—2122source
NTN6811JRZZ/5Kshielded, both sides8800—2210source
NTN6811LLB/2ASrubber seal8800—2261source
NTN6811JRLLBrubber seal8800—2284source
NTN6811LLBrubber seal8800—2690source
NTN6811JRLLB/2ASrubber seal8800—2699source
NTN6811ZZshielded, both sides8800—2801source
NTN6811LLUrubber seal8800—2930source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 55 mm bore falls in the ISO 286 band 50–80 mm, where IT7 is 30 µm wide. If the shaft seat is machined to h6, the shaft measures 54.981 to 55.000 mm; a H7/h6 pair at this nominal gives 0 to +49 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.