60 × 85 × 13 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 60 mm bore × 85 mm outside diameter × 13 mm width deep groove ball bearing, ToolLoop's index holds 13 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥1,692 against NTN at ¥2,392 — a 29.3% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6912C3open (no seal or shield)19400163001692source
NSK6912VVrubber seal19400163002212source
NSK6912open (no seal or shield)19400163002225source
NSK6912ZZshielded, both sides19400163002297source
NSK6912DDUrubber seal19400163002850source
NTN6912ZZ/2ASshielded, both sides16400—2281source
NTN6912open (no seal or shield)16400—2392source
NTN6912ZZNR/2ASshielded, both sides16400—2430source
NTN6912ZZshielded, both sides16400—2487source
NTN6912LLB/2ASrubber seal16400—2522source
NTN6912LLU/2ASrubber seal16400—2558source
NTN6912LLBrubber seal16400—3041source
NTN6912LLUrubber seal16400—3104source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 60 mm bore falls in the ISO 286 band 50–80 mm, where IT7 is 30 µm wide. If the shaft seat is machined to h6, the shaft measures 59.981 to 60.000 mm; a H7/h6 pair at this nominal gives 0 to +49 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.