65 × 85 × 10 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 65 mm bore × 85 mm outside diameter × 10 mm width deep groove ball bearing, ToolLoop's index holds 11 listings across NTN and NSK. In the sealed variant the cheapest listing is NSK at ¥3,128 against NTN at ¥3,530 — a 11.4% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6813DDrubber seal11900121003128source
NSK6813ZZshielded, both sides11900121003556source
NSK6813DDUrubber seal11900121003584source
NSK6813open (no seal or shield)11900121003603source
NSK6813VVrubber seal11900121003867source
NTN6813ZZshielded, both sides11600—3245source
NTN6813LLU/5Krubber seal11600—3530source
NTN6813LLB/2ASrubber seal11600—3534source
NTN6813open (no seal or shield)11600—3539source
NTN6813LLUrubber seal11600—3552source
NTN6813LLBrubber seal11600—3857source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 65 mm bore falls in the ISO 286 band 50–80 mm, where IT7 is 30 µm wide. If the shaft seat is machined to h6, the shaft measures 64.981 to 65.000 mm; a H7/h6 pair at this nominal gives 0 to +49 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.