75 × 105 × 16 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 75 mm bore × 105 mm outside diameter × 16 mm width deep groove ball bearing, ToolLoop's index holds 12 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥2,603 against NTN at ¥2,998 — a 13.2% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6915C3open (no seal or shield)24400226002603source
NSK6915VVrubber seal24400226003363source
NSK6915open (no seal or shield)24400226003639source
NSK6915ZZshielded, both sides24400226003689source
NSK6915DDUrubber seal24400226003833source
NTN6915open (no seal or shield)24400—2998source
NTN6915ZZshielded, both sides24400—3393source
NTN6915LLU/2ASrubber seal24400—3549source
NTN6915ZZ/2ASshielded, both sides24400—3575source
NTN6915LLB/2ASrubber seal24400—3711source
NTN6915LLBrubber seal24400—3973source
NTN6915LLUrubber seal24400—4343source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 75 mm bore falls in the ISO 286 band 50–80 mm, where IT7 is 30 µm wide. If the shaft seat is machined to h6, the shaft measures 74.981 to 75.000 mm; a H7/h6 pair at this nominal gives 0 to +49 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.