75 × 95 × 10 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 75 mm bore × 95 mm outside diameter × 10 mm width deep groove ball bearing, ToolLoop's index holds 7 listings across NTN and NSK. In the sealed variant the cheapest listing is NSK at ¥3,938 against NTN at ¥4,620 — a 14.8% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6815open (no seal or shield)12500139003923source
NSK6815VVrubber seal12500139003938source
NSK6815DDUrubber seal12500139004473source
NSK6815ZZshielded, both sides12500139004636source
NTN6815open (no seal or shield)12500—3549source
NTN6815ZZ/2ASshielded, both sides12500—4609source
NTN6815LLUrubber seal12500—4620source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 75 mm bore falls in the ISO 286 band 50–80 mm, where IT7 is 30 µm wide. If the shaft seat is machined to h6, the shaft measures 74.981 to 75.000 mm; a H7/h6 pair at this nominal gives 0 to +49 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.