85 × 130 × 22 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 85 mm bore × 130 mm outside diameter × 22 mm width deep groove ball bearing, ToolLoop's index holds 23 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥4,184 against NSK at ¥4,979 — a 19.0% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6017C3open (no seal or shield)49500430003685source
NSK6017VVrubber seal49500430004377source
NSK6017DDUrubber seal49500430004647source
NSK6017DDUCMrubber seal49500430004752source
NSK6017VVCMrubber seal49500430004752source
NSK6017NRopen (no seal or shield)49500430004790source
NSK6017ZZshielded, both sides49500430004979source
NSK6017open (no seal or shield)49500430005366source
NSK6017P5open (no seal or shield)495004300012460source
NTN6017ZZCMshielded, both sides49500—4184source
NTN6017LLBCMrubber seal49500—4316source
NTN6017CMopen (no seal or shield)49500—4355source
NTN6017ZZCM/5Kshielded, both sides49500—4380source
NTN6017ZCMshielded, one side49500—4498source
NTN6017ZZshielded, both sides49500—4576source
NTN6017LLBrubber seal49500—4865source
NTN6017LLBCM/5Krubber seal49500—4877source
NTN6017LLUrubber seal49500—5087source
NTN6017open (no seal or shield)55000—5092source
NTN6017LLB/2ASrubber seal49500—5147source
NTN6017LUrubber seal49500—5514source
NTN6017ZZNRshielded, both sides49500—5559source
NTN6017ZZC3/5Kshielded, both sides49500—5824source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 85 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 84.978 to 85.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.