90 × 140 × 24 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 90 mm bore × 140 mm outside diameter × 24 mm width deep groove ball bearing, ToolLoop's index holds 23 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥4,867 against NSK at ¥5,713 — a 17.4% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6018C3open (no seal or shield)58000500004451source
NSK6018VVrubber seal58000500005476source
NSK6018DDUC3rubber seal58000500005514source
NSK6018VVCMrubber seal58000500005676source
NSK6018ZZshielded, both sides58000500005713source
NSK6018DDUrubber seal58000500005737source
NSK6018open (no seal or shield)58000500006260source
NSK6018Mopen (no seal or shield)58000500006978source
NSK6018P5open (no seal or shield)580005000012818source
NTN6018open (no seal or shield)58000—4533source
NTN6018CMopen (no seal or shield)58000—4564source
NTN6018C3open (no seal or shield)58000—4790source
NTN6018ZZCMshielded, both sides58000—4867source
NTN6018LLBC3rubber seal58000—5058source
NTN6018LLUCMrubber seal58000—5058source
NTN6018ZZCM/5Kshielded, both sides58000—5151source
NTN6018ZZshielded, both sides58000—5525source
NTN6018LLUCM/5Krubber seal58000—5575source
NTN6018LLB/2ASrubber seal58000—5932source
NTN6018LLBrubber seal58000—6066source
NTN6018LLBC3/2ASrubber seal58000—6579source
NTN6018ZZC3/5Kshielded, both sides58000—6689source
NTN6018LLUrubber seal58000—6751source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 90 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 89.978 to 90.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.