90 × 190 × 43 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 90 mm bore × 190 mm outside diameter × 43 mm width deep groove ball bearing, ToolLoop's index holds 21 listings across NTN and NSK. In the sealed variant the cheapest listing is NTN at ¥13,396 against NSK at ¥15,413 — a 15.1% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6318C3Eopen (no seal or shield)14300010700010192source
NSK6318C3open (no seal or shield)14300010700011188source
NSK6318ZZshielded, both sides14300010700013264source
NSK6318ZZC3shielded, both sides14300010700013499source
NSK6318open (no seal or shield)14300010700015198source
NSK6318VVC3rubber seal14300010700015413source
NSK6318DDUrubber seal14300010700020549source
NTN6318CMopen (no seal or shield)143000—11324source
NTN6318C3open (no seal or shield)143000—11472source
NTN6318ZZC3/5Kshielded, both sides143000—11567source
NTN6318ZZCMshielded, both sides143000—11824source
NTN6318open (no seal or shield)143000—12058source
NTN6318ZZshielded, both sides143000—12311source
NTN6318Zshielded, one side143000—12475source
NTN6318ZZC3shielded, both sides143000—12830source
NTN6318ZZCM/5Kshielded, both sides143000—12921source
NTN6318LLUCMrubber seal143000—13396source
NTN6318ZCMshielded, one side143000—13594source
NTN6318LLUCM/5Krubber seal143000—15342source
NTN6318LLUrubber seal143000—16055source
NTN6318L1CMopen (no seal or shield)143000—17681source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 90 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 89.978 to 90.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.