95 × 170 × 32 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 95 mm bore × 170 mm outside diameter × 32 mm width deep groove ball bearing, ToolLoop's index holds 20 listings across NTN and NSK. In the open variant the cheapest listing is NTN at ¥5,168 against NSK at ¥5,799 — a 12.2% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6219ZZCMNS7shielded, both sides109000820005496source
NSK6219C4open (no seal or shield)109000820005799source
NSK6219C3Eopen (no seal or shield)109000820005935source
NSK6219open (no seal or shield)109000820006552source
NSK6219ZZshielded, both sides109000820006842source
NSK6219NRopen (no seal or shield)109000820007805source
NSK6219DDUrubber seal109000820008365source
NSK6219VVrubber seal109000820008365source
NSK6219MC3open (no seal or shield)109000820009223source
NSK6219Mopen (no seal or shield)109000820009660source
NTN6219C3open (no seal or shield)109000—5168source
NTN6219CMopen (no seal or shield)109000—5757source
NTN6219open (no seal or shield)109000—5997source
NTN6219ZZCMshielded, both sides109000—6181source
NTN6219ZZCM/5Kshielded, both sides109000—7088source
NTN6219ZZshielded, both sides109000—7424source
NTN6219Zshielded, one side109000—7659source
NTN6219ZZC3/5Kshielded, both sides109000—7720source
NTN6219LLBCM/5Krubber seal109000—7980source
NTN6219LLBrubber seal109000—8093source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 95 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 94.978 to 95.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.