95 × 200 × 45 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 95 mm bore × 200 mm outside diameter × 45 mm width deep groove ball bearing, ToolLoop's index holds 15 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥14,899 against NSK at ¥19,594 — a 31.5% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6319C3Eopen (no seal or shield)15300011900012899source
NSK6319C3open (no seal or shield)15300011900014156source
NSK6319open (no seal or shield)15300011900015174source
NSK6319ZZshielded, both sides15300011900019594source
NSK6319VVrubber seal15300011900021941source
NTN6319C3open (no seal or shield)153000—13056source
NTN6319ZZCMshielded, both sides153000—14899source
NTN6319CMopen (no seal or shield)153000—15305source
NTN6319open (no seal or shield)153000—15372source
NTN6319ZZCM/5Kshielded, both sides153000—17856source
NTN6319ZCMshielded, one side153000—17888source
NTN6319ZZshielded, both sides153000—17913source
NTN6319ZC3shielded, one side153000—18208source
NTN6319LLUrubber seal153000—19132source
NTN6319LLU/2ASrubber seal153000—19132source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 95 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 94.978 to 95.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.