100 × 150 × 24 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 100 mm bore × 150 mm outside diameter × 24 mm width deep groove ball bearing, ToolLoop's index holds 20 listings across NTN and NSK. In the open variant the cheapest listing is NTN at ¥5,723 against NSK at ¥8,577 — a 49.9% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6020ZCMshielded, one side60000540006589source
NSK6020ZZshielded, both sides60000540007037source
NSK6020VVrubber seal60000540007811source
NSK6020DDUrubber seal60000540007881source
NSK6020MC3open (no seal or shield)60000540008577source
NSK6020P5open (no seal or shield)600005400019032source
NTN6020C3open (no seal or shield)60000—5723source
NTN6020CMopen (no seal or shield)60000—6517source
NTN6020ZZCMshielded, both sides60000—6620source
NTN6020C4open (no seal or shield)60000—6900source
NTN6020open (no seal or shield)60000—6987source
NTN6020ZZC3shielded, both sides60000—6987source
NTN6020ZZshielded, both sides60000—7215source
NTN6020ZZCM/5Kshielded, both sides60000—7475source
NTN6020Zshielded, one side60000—7742source
NTN6020LUrubber seal—7980source
NTN6020LLUrubber seal60000—8183source
NTN6020LLU/2ASrubber seal60000—8252source
NTN6020ZZC3/5Kshielded, both sides60000—8944source
NTN6020ZZC4/5Kshielded, both sides60000—9181source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 100 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 99.978 to 100.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.