100 × 215 × 47 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 100 mm bore × 215 mm outside diameter × 47 mm width deep groove ball bearing, ToolLoop's index holds 15 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥19,423 against NSK at ¥23,127 — a 19.1% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6320C3Eopen (no seal or shield)17300014100016840source
NSK6320C3open (no seal or shield)17300014100018483source
NSK6320open (no seal or shield)17300014100019977source
NSK6320ZZshielded, both sides17300014100023127source
NSK6320VVrubber seal17300014100023493source
NSK6320DDUrubber seal17300014100024180source
NTN6320C4open (no seal or shield)173000—19299source
NTN6320ZZCMshielded, both sides173000—19423source
NTN6320CMopen (no seal or shield)173000—19626source
NTN6320C3open (no seal or shield)173000—20044source
NTN6320ZCMshielded, one side173000—21912source
NTN6320Zshielded, one side173000—23163source
NTN6320ZZshielded, both sides173000—23163source
NTN6320ZZCM/5Kshielded, both sides173000—23163source
NTN6320L1C3open (no seal or shield)—28512source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 100 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 99.978 to 100.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.