105 × 190 × 36 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 105 mm bore × 190 mm outside diameter × 36 mm width deep groove ball bearing, ToolLoop's index holds 11 listings across NTN and NSK. In the open variant the cheapest listing is NTN at ¥11,351 against NSK at ¥13,444 — a 18.4% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6221open (no seal or shield)13300010500013444source
NSK6221MC3open (no seal or shield)13300010500015284source
NSK6221Mopen (no seal or shield)13300010500015588source
NTN6221ZZCMshielded, both sides133000—10935source
NTN6221Zshielded, one side133000—11216source
NTN6221C3open (no seal or shield)133000—11351source
NTN6221CMopen (no seal or shield)133000—11351source
NTN6221NRopen (no seal or shield)133000—11634source
NTN6221ZZC3/5Kshielded, both sides133000—11641source
NTN6221ZZCM/5Kshielded, both sides133000—11652source
NTN6221LLU/2ASrubber seal133000—12437source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 105 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 104.978 to 105.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.