110 × 200 × 38 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 110 mm bore × 200 mm outside diameter × 38 mm width deep groove ball bearing, ToolLoop's index holds 14 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥10,110 against NTN at ¥12,379 — a 18.3% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6222C3Eopen (no seal or shield)14400011700010110source
NSK6222C3open (no seal or shield)14400011700011375source
NSK6222ZCMshielded, one side14400011700012859source
NSK6222CMopen (no seal or shield)14400011700014714source
NSK6222ZZshielded, both sides14400011700017464source
NSK6222MC3open (no seal or shield)14400011700019899source
NTN6222C3open (no seal or shield)144000—12379source
NTN6222CMopen (no seal or shield)144000—13415source
NTN6222NRopen (no seal or shield)144000—14459source
NTN6222Zshielded, one side144000—14731source
NTN6222ZZCM/5Kshielded, both sides144000—15293source
NTN6222ZZCMshielded, both sides144000—15314source
NTN6222ZZ/2ASshielded, both sides144000—15992source
NTN6222LLU/2ASrubber seal144000—17310source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 110 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 109.978 to 110.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.