120 × 180 × 28 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 120 mm bore × 180 mm outside diameter × 28 mm width deep groove ball bearing, ToolLoop's index holds 16 listings across NTN and NSK. In the open variant the cheapest listing is NTN at ¥12,970 against NSK at ¥17,946 — a 38.4% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6024Zshielded, one side880008000011346source
NSK6024ZZshielded, both sides880008000012601source
NSK6024ZC4shielded, one side880008000013839source
NSK6024Mopen (no seal or shield)880008000017946source
NSK6024MC3open (no seal or shield)880008000017946source
NTN6024CMopen (no seal or shield)85000—12970source
NTN6024ZC4shielded, one side85000—13030source
NTN6024ZZC3/5Kshielded, both sides85000—13467source
NTN6024Zshielded, one side85000—13573source
NTN6024ZZshielded, both sides85000—13863source
NTN6024LLB/2ASrubber seal85000—14736source
NTN6024NRopen (no seal or shield)85000—15395source
NTN6024ZZNR/2ASshielded, both sides85000—15745source
NTN6024LLUC3/5Krubber seal85000—16028source
NTN6024LLUrubber seal85000—16584source
NTN6024LUrubber seal85000—16617source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 120 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 119.978 to 120.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.