12 × 18 × 4 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 12 mm bore × 18 mm outside diameter × 4 mm width deep groove ball bearing, ToolLoop's index holds 8 listings across NTN and NSK. In the open variant the cheapest listing is NSK at ¥678 against NTN at ¥968 — a 30.0% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6701open (no seal or shield)928532678source
NSK6701ZZshielded, both sides928532766source
NSK6701DDrubber seal928532974source
NSK6701-H-DDrubber seal7894251361source
NSK6701-H-ZZshielded, both sides7894251385source
NTN6701LLFrubber seal930—833source
NTN6701LLF/5Krubber seal930—900source
NTN6701open (no seal or shield)930—968source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 12 mm bore falls in the ISO 286 band 10–18 mm, where IT7 is 18 µm wide. If the shaft seat is machined to h6, the shaft measures 11.989 to 12.000 mm; a H7/h6 pair at this nominal gives 0 to +29 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.