30 × 42 × 7 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 30 mm bore × 42 mm outside diameter × 7 mm width deep groove ball bearing, ToolLoop's index holds 25 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥926 against NSK at ¥1,220 — a 31.7% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6806open (no seal or shield)470036501151source
NSK6806DDrubber seal470036501172source
NSK6806DDUrubber seal470036501196source
NSK6806ZZshielded, both sides470036501220source
NSK6806ZZNRshielded, both sides470036501240source
NSK6806VVrubber seal470036501278source
NTN6806JRZZ/5Kshielded, both sides4700—926source
NTN6806JRZZCMshielded, both sides4700—942source
NTN6806open (no seal or shield)4700—1005source
NTN6806JRopen (no seal or shield)4700—1034source
NTN6806LLU/2ASrubber seal4700—1044source
NTN6806ZZ/2ASshielded, both sides4700—1056source
NTN6806JRZZCM/5Kshielded, both sides4700—1059source
NTN6806ZZCMshielded, both sides4700—1064source
NTN6806JRZshielded, one side4700—1154source
NTN6806JRLLBrubber seal4700—1163source
NTN6806JRZZshielded, both sides4700—1181source
NTN6806JRZZNR/2ASshielded, both sides4700—1222source
NTN6806ZZshielded, both sides4700—1228source
NTN6806ZZNR/2ASshielded, both sides4700—1250source
NTN6806JRZZNRshielded, both sides4700—1300source
NTN6806JRZZC3/5Kshielded, both sides4700—1310source
NTN6806LLUrubber seal4700—1351source
NTN6806LLBrubber seal4700—1366source
NTN6806ZZNRshielded, both sides4700—1857source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 30 mm bore falls in the ISO 286 band 18–30 mm, where IT7 is 21 µm wide. If the shaft seat is machined to h6, the shaft measures 29.987 to 30.000 mm; a H7/h6 pair at this nominal gives 0 to +34 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.