80 × 125 × 22 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 80 mm bore × 125 mm outside diameter × 22 mm width deep groove ball bearing, ToolLoop's index holds 24 listings across NTN and NSK. In the sealed variant the cheapest listing is NSK at ¥3,034 against NTN at ¥4,360 — a 30.4% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6016VVrubber seal47500400003034source
NSK6016DDUrubber seal47500400003195source
NSK6016ZZC3Eshielded, both sides47500400003553source
NSK6016ZZshielded, both sides47500400004212source
NSK6016open (no seal or shield)47500400004533source
NSK6016P5open (no seal or shield)475004000011096source
NTN6016CMopen (no seal or shield)47500—3778source
NTN6016ZZCM/5Kshielded, both sides47500—3854source
NTN6016ZZCMshielded, both sides47500—4002source
NTN6016ZZshielded, both sides47500—4081source
NTN6016Zshielded, one side47500—4272source
NTN6016open (no seal or shield)47500—4324source
NTN6016LLUrubber seal47500—4360source
NTN6016LLU/2ASrubber seal47500—4521source
NTN6016LLUC3rubber seal47500—4672source
NTN6016C3open (no seal or shield)—4720source
NTN6016C4open (no seal or shield)47500—4720source
NTN6016LLB/2ASrubber seal47500—4776source
NTN6016LLBrubber seal47500—4780source
NTN6016ZZC3/5Kshielded, both sides47500—4971source
NTN6016ZC3shielded, one side47500—5090source
NTN6016LUrubber seal47500—5470source
NTN6016LLUC3/5Krubber seal47500—5630source
NTN6016L1C3P6open (no seal or shield)47500—7700source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 80 mm bore falls in the ISO 286 band 50–80 mm, where IT7 is 30 µm wide. If the shaft seat is machined to h6, the shaft measures 79.981 to 80.000 mm; a H7/h6 pair at this nominal gives 0 to +49 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.