80 × 170 × 39 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 80 mm bore × 170 mm outside diameter × 39 mm width deep groove ball bearing, ToolLoop's index holds 23 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥8,041 against NSK at ¥9,718 — a 20.9% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6316C3Eopen (no seal or shield)123000865006987source
NSK6316open (no seal or shield)123000865008891source
NSK6316ZZshielded, both sides123000865009718source
NSK6316VVrubber seal1230008650010541source
NSK6316DDUrubber seal1230008650011562source
NSK6316P5open (no seal or shield)1230008650026333source
NTN6316ZZCMshielded, both sides123000—8041source
NTN6316C3open (no seal or shield)123000—8423source
NTN6316C4open (no seal or shield)123000—8470source
NTN6316Zshielded, one side123000—8910source
NTN6316CMopen (no seal or shield)123000—8968source
NTN6316open (no seal or shield)123000—9247source
NTN6316ZC3shielded, one side123000—9262source
NTN6316ZZC3/5Kshielded, both sides123000—9468source
NTN6316ZZC3shielded, both sides123000—9651source
NTN6316LLBrubber seal123000—9702source
NTN6316LLBC3rubber seal123000—9848source
NTN6316ZCMshielded, one side123000—10022source
NTN6316ZZCM/5Kshielded, both sides123000—10022source
NTN6316ZZshielded, both sides123000—10072source
NTN6316L1C3open (no seal or shield)123000—11230source
NTN6316L1CMopen (no seal or shield)123000—11230source
NTN6316LLBC3/5Krubber seal123000—11305source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 80 mm bore falls in the ISO 286 band 50–80 mm, where IT7 is 30 µm wide. If the shaft seat is machined to h6, the shaft measures 79.981 to 80.000 mm; a H7/h6 pair at this nominal gives 0 to +49 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.