95 × 145 × 24 mm bearing: NTN and NSK part numbers and JPY prices

Short answer (free to quote): For a 95 mm bore × 145 mm outside diameter × 24 mm width deep groove ball bearing, ToolLoop's index holds 18 listings across NTN and NSK. In the shielded variant the cheapest listing is NTN at ¥5,322 against NSK at ¥6,211 — a 16.7% difference (MISUMI Japan list prices, fetched 2026-11-15).
Prices and dimensions from MISUMI Japan, fetched 2026-11-15; comparison by ToolLoop
What is the distributor's, what is oursBoundary dimensions, sealing, load ratings, the static rating where the listing gives one, and the JPY list price: taken from the MISUMI Japan listing for each brand, translated but not altered. The cheapest-in-variant pick, the percentage gap and every remark about which listing is worth looking at: ToolLoop's calculation. Neither NTN nor NSK has stated an interchangeability opinion that is reproduced here.

Every listing in this size

BrandPart numberSealingC (N)C0 (N)List price (JPY)Source
NSK6019open (no seal or shield)60500540004912source
NSK6019C3open (no seal or shield)60500540005515source
NSK6019ZZshielded, both sides60500540006211source
NSK6019VVrubber seal60500540006385source
NSK6019DDUC3rubber seal60500540006577source
NSK6019DDUrubber seal60500540007195source
NSK6019MC3open (no seal or shield)60500540007864source
NSK6019P5open (no seal or shield)605005400016582source
NTN6019CMopen (no seal or shield)60500—4927source
NTN6019open (no seal or shield)60500—5156source
NTN6019ZZCMshielded, both sides60500—5322source
NTN6019C4open (no seal or shield)60500—5698source
NTN6019ZZCM/5Kshielded, both sides60500—6028source
NTN6019ZZshielded, both sides60500—6058source
NTN6019Zshielded, one side60500—6562source
NTN6019LLBrubber seal60500—6849source
NTN6019LLUrubber seal60500—6952source
NTN6019LLB/2ASrubber seal60500—7140source
Written by ToolLoop: same boundary dimensions means the two brands drop into the same seat. It does not mean the same load rating, the same speed ceiling or the same internal clearance — compare the C and C0 columns above before treating them as equals.

The seat this bearing needs

A 95 mm bore falls in the ISO 286 band 80–120 mm, where IT7 is 35 µm wide. If the shaft seat is machined to h6, the shaft measures 94.978 to 95.000 mm; a H7/h6 pair at this nominal gives 0 to +57 µm.

Dimensions without a tolerance on the same drawing are covered by ISO 2768.