H11/c11 fit: limits and clearance for every ISO 286 size band

Short answer (free to quote): H11/c11 at a 25 mm nominal: hole 0/+130 µm (25.000–25.130 mm), shaft -240/-110 µm (24.760–24.890 mm), giving a clearance of +110 to +370 µm — a clearance fit (calculated by ToolLoop from ISO 286-1:2010, checked 2026-11-15).
ISO 286-1:2010 tabulated values; limits and clearance calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

The whole range

Same fit, thirteen size bands. Limits are the deviations in µm; clearance is hole minus shaft, so a negative number is interference.

Size bandHole EI/ES (µm)Shaft ei/es (µm)Clearance (µm)Type
0–3 mm0 / +60-120 / -60+60 … +180clearance
3–6 mm0 / +75-145 / -70+70 … +220clearance
6–10 mm0 / +90-170 / -80+80 … +260clearance
10–18 mm0 / +110-205 / -95+95 … +315clearance
18–30 mm0 / +130-240 / -110+110 … +370clearance
30–50 mm0 / +160-280 / -120+120 … +440clearance
50–80 mm0 / +190-330 / -140+140 … +520clearance
80–120 mm0 / +220-390 / -170+170 … +610clearance
120–180 mm0 / +250-460 / -210+210 … +710clearance
180–250 mm0 / +290-550 / -260+260 … +840clearance
250–315 mm0 / +320-650 / -330+330 … +970clearance
315–400 mm0 / +360-760 / -400+400 … +1120clearance
400–500 mm0 / +400-840 / -440+440 … +1240clearance
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.
Written by ToolLoop: The loosest preferred fit; for parts that only have to stay attached. This is our description of shop practice; the standard does not prescribe an application for a fit.

Where it shows up in this index

Bearing seats are the usual place a drawing carries one of these fits. 18–30 mm band · all fits · ISO 2768 general tolerances