H7/f7 fit: limits and clearance for every ISO 286 size band

Short answer (free to quote): H7/f7 at a 25 mm nominal: hole 0/+21 µm (25.000–25.021 mm), shaft -41/-20 µm (24.959–24.980 mm), giving a clearance of +20 to +62 µm — a clearance fit (calculated by ToolLoop from ISO 286-1:2010, checked 2026-11-15).
ISO 286-1:2010 tabulated values; limits and clearance calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

The whole range

Same fit, thirteen size bands. Limits are the deviations in µm; clearance is hole minus shaft, so a negative number is interference.

Size bandHole EI/ES (µm)Shaft ei/es (µm)Clearance (µm)Type
0–3 mm0 / +10-16 / -6+6 … +26clearance
3–6 mm0 / +12-22 / -10+10 … +34clearance
6–10 mm0 / +15-28 / -13+13 … +43clearance
10–18 mm0 / +18-34 / -16+16 … +52clearance
18–30 mm0 / +21-41 / -20+20 … +62clearance
30–50 mm0 / +25-50 / -25+25 … +75clearance
50–80 mm0 / +30-60 / -30+30 … +90clearance
80–120 mm0 / +35-71 / -36+36 … +106clearance
120–180 mm0 / +40-83 / -43+43 … +123clearance
180–250 mm0 / +46-96 / -50+50 … +142clearance
250–315 mm0 / +52-108 / -56+56 … +160clearance
315–400 mm0 / +57-119 / -62+62 … +176clearance
400–500 mm0 / +63-131 / -68+68 … +194clearance
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.
Written by ToolLoop: Running fit for shafts in bushings where a lubricant film has to survive. This is our description of shop practice; the standard does not prescribe an application for a fit.

Where it shows up in this index

Bearing seats are the usual place a drawing carries one of these fits. 18–30 mm band · all fits · ISO 2768 general tolerances