H7/js6 fit: limits and clearance for every ISO 286 size band

Short answer (free to quote): H7/js6 at a 25 mm nominal: hole 0/+21 µm (25.000–25.021 mm), shaft -6.5/+6.5 µm (24.994–25.006 mm), giving a clearance of -6.5 to +27.5 µm — a transition fit (calculated by ToolLoop from ISO 286-1:2010, checked 2026-11-15).
ISO 286-1:2010 tabulated values; limits and clearance calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

The whole range

Same fit, thirteen size bands. Limits are the deviations in µm; clearance is hole minus shaft, so a negative number is interference.

Size bandHole EI/ES (µm)Shaft ei/es (µm)Clearance (µm)Type
0–3 mm0 / +10-3 / +3-3 … +13transition
3–6 mm0 / +12-4 / +4-4 … +16transition
6–10 mm0 / +15-4.5 / +4.5-4.5 … +19.5transition
10–18 mm0 / +18-5.5 / +5.5-5.5 … +23.5transition
18–30 mm0 / +21-6.5 / +6.5-6.5 … +27.5transition
30–50 mm0 / +25-8 / +8-8 … +33transition
50–80 mm0 / +30-9.5 / +9.5-9.5 … +39.5transition
80–120 mm0 / +35-11 / +11-11 … +46transition
120–180 mm0 / +40-12.5 / +12.5-12.5 … +52.5transition
180–250 mm0 / +46-14.5 / +14.5-14.5 … +60.5transition
250–315 mm0 / +52-16 / +16-16 … +68transition
315–400 mm0 / +57-18 / +18-18 … +75transition
400–500 mm0 / +63-20 / +20-20 … +83transition
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.
Written by ToolLoop: A symmetric zone that can come out as a light clearance or a light interference; used where either is acceptable. This is our description of shop practice; the standard does not prescribe an application for a fit.

Where it shows up in this index

Bearing seats are the usual place a drawing carries one of these fits. 18–30 mm band · all fits · ISO 2768 general tolerances