H7/n6 fit: limits and clearance for every ISO 286 size band

Short answer (free to quote): H7/n6 at a 25 mm nominal: hole 0/+21 µm (25.000–25.021 mm), shaft +15/+28 µm (25.015–25.028 mm), giving a clearance of -28 to +6 µm — a transition fit (calculated by ToolLoop from ISO 286-1:2010, checked 2026-11-15).
ISO 286-1:2010 tabulated values; limits and clearance calculated by ToolLoop
What is standard text, what is our arithmeticThe tolerance and deviation values are the tabulated values of ISO 286-1:2010 / ISO 2768-1:1989, taken from three independently published open datasets and compared cell by cell; only cells where all datasets that carry them agree are shown. The standard documents themselves are not reproduced. The limit sizes in millimetres, the clearance/interference ranges and every sentence about which fit is used for what are calculated or written by ToolLoop — they are not quoted from the standard.

The whole range

Same fit, thirteen size bands. Limits are the deviations in µm; clearance is hole minus shaft, so a negative number is interference.

Size bandHole EI/ES (µm)Shaft ei/es (µm)Clearance (µm)Type
0–3 mm0 / +10+4 / +10-10 … +6transition
3–6 mm0 / +12+8 / +16-16 … +4transition
6–10 mm0 / +15+10 / +19-19 … +5transition
10–18 mm0 / +18+12 / +23-23 … +6transition
18–30 mm0 / +21+15 / +28-28 … +6transition
30–50 mm0 / +25+17 / +33-33 … +8transition
50–80 mm0 / +30+20 / +39-39 … +10transition
80–120 mm0 / +35+23 / +45-45 … +12transition
120–180 mm0 / +40+27 / +52-52 … +13transition
180–250 mm0 / +46+31 / +60-60 … +15transition
250–315 mm0 / +52+34 / +66-66 … +18transition
315–400 mm0 / +57+37 / +73-73 … +20transition
400–500 mm0 / +63+40 / +80-80 … +23transition
Provenance: primary table ottonic/standards-mcp-server (src/domain/iso286.ts, MIT); cross-checked against clay-good/anvilate (tolerance/data/iso286_*.yaml, MIT) and chenzefeng09/iso-286-fits (fits.json, MIT). 393 overlapping cells compared, 0 disagreements, checked 2026-11-15.
Written by ToolLoop: A press fit that still allows dismantling. This is our description of shop practice; the standard does not prescribe an application for a fit.

Where it shows up in this index

Bearing seats are the usual place a drawing carries one of these fits. 18–30 mm band · all fits · ISO 2768 general tolerances